Flat cover for Jeanneau Cap Camarat 7.5 WA S3 deck

The mooring cover is particularly useful for protecting the upholstery and the polyester hull of the boat. The upholstery, which includes cushions, seats, and other fabric accessories, is especially vulnerable to natural elements that can cause fading and rapid deterioration. Using a custom cover protects the upholstery from UV rays, rain, wind, and other natural elements that can damage them.

When you invest in a Cap Camarat 7.5 WA S3 boat, it is essential to ensure its protection against natural elements.

This protective cover covers your boat from front to back except for the balconies. It is perfectly fitted, which is a mark of quality in the design and will allow it to protect your boat from bad weather and sun for a long time.

Save time on maintenance to benefit more time for sailing. Extend the longevity and value of your Jeanneau Cap Camarat 7.5 WA S3.

Our boat cover is made to your preference either:

• in nautical quality polyester tarp coated on both sides, weighing 325g/m² and in gray color.
• or in polyester fabric which has the appearance of cloth

We favor the natural attachments found on the boat to secure the mooring cover. Thus, no drilling is required.

The nautical fabric is held at the cleats and the feet of the balconies either by:
- straps that wrap around the stainless steel balconies and/or the cleats and are threaded through a ladder lock buckle and then tightened by pulling firmly. (the ladder lock is the flat buckle you find on backpacks, for example)
- bungee cords that wrap around the stainless steel balconies and/or the cleats passing through eyelets.

The outboard motor is not covered; we invite you to check the covers we offer to cover motors.

Each cover is custom-made because we take into account the nautical equipment of your boat (photos required). By nautical equipment, we mean: bimini, arches, roll bar, tow mast, navigation light, antenna, etc. Please specify any particular features when ordering.

This protective tarp is to be used on land or at anchor. It should not remain on the boat during transport, for two reasons: first, for safety reasons, the cover should not come loose, and second, the friction caused by speed could damage the boat’s surface, causing premature wear.

It is important to note that the cover is not designed to withstand strong winds such as storms, cyclones, or hurricanes. It must be removed before bad weather.

The strong wind effect is amplified when the boat is on land on a cradle, that is, elevated, and even more so if it is not facing the prevailing wind.