Flat Deck Cover for Prua Al Vento Jaguar 7.0

Using a mooring cover is one of the most effective ways to protect your boat from the sun’s rays, rain and other elements that can damage the hull and upholstery. Polyester is a material commonly used in boat construction. Although it is resistant to UV rays, it can deteriorate over time when exposed to the elements. UV rays can cause the polyester surface to fade and deteriorate. Using a mooring cover protects the polyester surface from UV rays, thereby extending the life of your boat.

When you invest in a Jaguar 7.0 boat, it is essential to protect it from the elements.

This protective cover covers your boat from bow to stern, except for the guardrails. It is made to fit perfectly, a mark of quality craftsmanship that helps protect your boat from bad weather and the sun for years to come.

Spend less time on maintenance and more time out on the water. Extend the life and preserve the value of your Prua Al Vento Jaguar 7.0.

Our boat cover is made to suit your preferences, in either:

• 325 g/m² marine-grade polyester tarpaulin coated on both sides.
• Polyester fabric with the look of woven cloth

To ensure a secure fit, all existing attachment points on the boat are used, avoiding the need to drill holes.

The marine fabric is secured around the cleats and the guardrail bases using either:
- Straps that wrap around the stainless-steel guardrails and/or cleats and thread through a ladder-lock buckle, then tighten by pulling firmly. (A ladder-lock buckle is the flat buckle commonly found on backpacks, for example.)
- Bungee cords that wrap around the stainless-steel guardrails and/or cleats and pass through eyelets.

The outboard motor is not covered. Please see the covers we offer for protecting motors.

Each cover is made to measure, taking your boat’s equipment into account (photos required). This includes equipment such as a bimini, hoops, roll bar, ski pylon, navigation light, antenna, etc. Please specify any details when placing your order.

This protective cover is for use on land or at anchor. It must not be left on the boat while it is being transported for two reasons: first, for safety, as the cover could come loose; and second, because friction caused by the speed could damage the boat’s surface and wear it prematurely.

Please note that the cover is not designed to withstand strong winds, such as those caused by storms, cyclones or hurricanes. It must be removed before such weather conditions arrive.

Strong winds have a greater impact when the boat is ashore on a cradle, especially when it is elevated and even more so if it is not facing into the prevailing wind.