Flat Deck Cover for Prua Al Vento Jaguar 6.0

Using a mooring cover is one of the most effective ways to protect your boat from the sun’s rays, rain and other elements that can damage the hull and upholstery. Polyester is a material commonly used in boat construction. Although it is resistant to UV rays, it can deteriorate over time when exposed to the elements. UV rays can cause polyester surfaces to fade and deteriorate. Using a mooring cover protects the polyester surface from UV rays, thereby extending the life of your boat.

When you invest in a Jaguar 6.0 boat, it is essential to protect it from the elements.

This protective cover covers your boat from bow to stern, except for the guardrails. It is perfectly fitted, a mark of quality craftsmanship, and will protect your boat from bad weather and the sun for a long time.

Spend less time on maintenance and more time out on the water. Extend the lifespan and preserve the value of your Prua Al Vento Jaguar 6.0.

Our boat cover is made to suit your needs, in either:

• Marine-grade polyester tarpaulin, coated on both sides, weighing 325 g/m².
• or polyester fabric with the look of woven cloth

To ensure the cover stays in place, all existing attachment points on the boat are used, avoiding the need to drill holes.

The marine fabric is secured around the cleats and guardrail bases using either:
- Straps that wrap around the stainless-steel guardrails and/or cleats, then thread through a ladder-lock buckle and are tightened by pulling firmly. (A ladder-lock buckle is the flat buckle commonly found on backpacks, for example.)
- Bungee cords that wrap around the stainless-steel guardrails and/or cleats and pass through eyelets.

The outboard motor is not covered. Please see the covers we offer for protecting motors.

Each cover is made to measure, taking into account your boat’s equipment (photos required). Boat equipment includes a bimini, support poles, a roll bar, a tow arch, a navigation light, an antenna, etc. Please specify any requirements when ordering.

This protective cover is intended for use ashore or at anchor. It should not be left on the boat during transport for two reasons: first, for safety, as the cover could come loose; and second, wind friction at speed could damage the boat’s surface, causing premature wear.

Please note that the cover is not designed to withstand strong winds such as those associated with storms, cyclones or hurricanes. It must be removed before severe weather.

Strong winds have an even greater effect when the boat is ashore on a stand, where it is elevated, especially if it is not facing the prevailing wind.