Flat deck cover for Jeanneau Cap Camarat 7.5 CC S3

A mooring cover is particularly useful for protecting the boat’s upholstery and polyester hull. The upholstery, including cushions, seats and other fabric accessories, is especially vulnerable to the elements, which can cause it to fade and deteriorate quickly. A custom-made cover protects the upholstery from UV rays, rain, wind and other natural elements that can damage it.

When you invest in a Cap Camarat 7.5 CC S3 boat, it is essential to protect it from the elements.

This full boat cover, from bow to stern, excluding the rails, protects your boat from bad weather, dirt and UV damage.

Spend less time on maintenance and more time out on the water. Extend the life and preserve the value of your Jeanneau Cap Camarat 7.5 CC S3.

Our boat cover is made to suit your preference, either:

• in marine-grade polyester canvas coated on both sides, weighing 325 g/m².
• or in polyester fabric with a fabric-like appearance

We use the boat’s existing attachment points to secure the mooring cover, so no drilling is required.

The marine fabric is secured around the cleats and rail supports using either:
- Straps wrapped around the stainless-steel rails and/or cleats, then threaded through a ladder-lock buckle and pulled tight. (A ladder-lock buckle is the flat buckle often found on backpacks, for example.)
- Shock cord wrapped around the stainless-steel rails and/or cleats and passed through eyelets.

The outboard motor is not covered. Please see the covers we offer for protecting motors.

Each cover is made to measure to accommodate your boat’s equipment (photos required). This includes items such as a bimini, frames, roll bar, tow arch, navigation light, antenna, etc. Please specify any requirements when placing your order.

This protective cover is intended for use on land or at anchor. It must be removed before transporting the boat for two reasons: first, for safety, as the cover could come loose; and second, friction caused by the speed could damage the boat’s surface and cause premature wear.

Please note that the cover is not designed to withstand strong winds, such as those during storms, cyclones or hurricanes. It must be removed before these weather events arrive.

Strong winds have a greater effect when the boat is ashore on a cradle, where it is raised off the ground, and even more so if it is not facing into the prevailing wind.

Watch the video to see how to install the cover. You’ll see that installation requires no drilling.