Flat Deck Cover Ranieri Voyager 26 S

Using a mooring cover is one of the most effective ways to protect your boat from the sun's rays, rain and other elements that can damage the hull and upholstery. Polyester is a material commonly used in boatbuilding. Although it is resistant to UV rays, it can deteriorate over time when exposed to the elements. UV rays can cause fading and damage to the polyester surface. Using a mooring cover protects the polyester surface from UV rays, thereby extending the life of your boat.

When you invest in a Voyager 26 S boat, it is essential to protect it from the elements.

This full boat cover, from bow to stern, excluding the rails, protects your boat from bad weather, dirt and UV damage.

Spend less time on maintenance and more time out on the water. Extend the life and preserve the value of your Ranieri Voyager 26 S.

Our boat cover is made to your preference in either:

• Marine-grade polyester tarpaulin, coated on both sides and weighing 325 g/m².
• Polyester fabric with a woven-fabric appearance

To ensure a secure fit, all existing attachment points on the boat are used to avoid drilling holes.

The marine fabric is secured around the cleats and at the bases of the rails either with:
- Straps that wrap around the stainless-steel rails and/or cleats, then feed through a ladder-lock buckle and are tightened by pulling firmly. (A ladder-lock buckle is the flat buckle commonly found on backpacks, for example.)
- Bungee cords that wrap around the stainless-steel rails and/or cleats and pass through eyelets.

The outboard motor is not covered. Please see the covers we offer for protecting motors.

Each cover is made to measure, taking into account your boat's equipment (photos required). This includes items such as a bimini, frames, roll bar, tow mast, navigation light, antenna, etc. Please specify any requirements when placing your order.

This protective cover is intended for use on land or at mooring. It should not remain on the boat during transport, for two reasons: first, for safety, as the cover could come loose; and second, friction caused by speed could damage the boat's surface and cause premature wear.

Please note that the cover is not designed to withstand strong winds, such as those caused by storms, cyclones or hurricanes. It must be removed before these weather events arrive.

Strong winds have an even greater effect when the boat is on land on a cradle, that is, raised off the ground, especially if it is not facing the prevailing wind.